The Forming Fabric is a device for paper forming and dewatering on the paper machine.
It dehydrates the pulp suspension from the headbox and runs the paper web to the subsequent section. In the past, copper mesh was mostly used, but now polyester molding mesh is mostly used, which is mainly woven from polyester monofilament. In order to increase the service life, some manufacturers add nylon monofilament weaving with better wear resistance in the middle of weft.
1.Long service life, wear resistance and low net consumption.
2. High fatigue strength, acid and alkali resistance.
3. Light net mark and good molding quality.
4. Light weight, convenient transportation and easy operation.
A sheet of paper begins in the forming section, where a mixture of 99% water and 1% cellulose fiber is introduced evenly across a forming fabric, which acts as both a sheet conveyor and a dewatering device. It is here that the paper sheet is formed and the initial water removal occurs. As the fabric moves, water drains through it, while the fibers and fillers that form the sheet remain on top. Today, forming fabrics have an average operating life of 45 to 60 days.
Single layer forming fabric, double layer forming fabric, triple later forming fabric
Factory & Advanced Equipment
Sun Hong Forming Fabric produced withimported Equipment 14m German Weaving machine.Wide weaving width makes surethe rate of finished products yields . Austria Automatic seaming machine obtains Average splice point and strong constructions andNorway 14.5m heatsetting machine . Sun Hong Forming Fabric is characterized.
Our fabrics are avallable in a variety of woven patterns, mesh count, thread diameter, surface topography and air permeability uponyour request.
How to Install Forming Fabric
1. Before installing the forming wire, kindly check the equipment if it is in good condition, the surface of wires should be forbidden from unevenness, slanting, burr, sand, etc.
2. The running direction must be in accordance with the direction of the arrow on the wire, the wire should be placed in the correct position, and the rollers should be paralleled with each other to prevent the wires from being deflected.
3. There should be a swinging high-pressure water device that used to wash wire. Water pressure is not lower than 6-10 kg/cm² for the medium and low-speed paper machine; speed more than 350m/min, water pressure is not lower than 10-15 kg/cm²; When using multi-layer forming wire, water pressure is not lower than 15-30 kg/cm², meanwhile water should be clean and without sand.
4. When installing the forming wire, firstly let the wire be slightly tensioned, add water to lubricate the operation, adjust the tension to normal after sizing, keep the tension of the low-speed paper machine at 3-4 kg/cm², and high speed one at 4-6 kg/cm².
Bubble Film and waste thick fabric wrapping while protecting inside fabric.
Wrapped special fabric package outside(Air shipping ).
Composite wooden box(sea shipping ).
Audited Supplier 
){kind=link}